Hello everyone. So. We didn't' actually do much relating to this project. For the past couple of weeks Richard and I have been at a bit of a stand still. You see, Richard and I have made it to a state level competition in product design, specializing in 3D printing. We also got the information extremely late so we've been working super hard to prepare for that and meet the deadline.
This was not the only speed bump that we ran into either. We ordered all of the parts that we need to get started however the main package with all of the electronics, control board, gps, gyro, etc, are shipping international and will not be here until the end of this week or next week. This means we've had very little to work on since the last post relating to the project.
Hopefully next week we'll have something more to show and we can start making progress again.
Spence, I don't blame you for not working over break and before your competition! I would recommend though, while you're waiting, make sure you've read the manuals for the equipment you're going to be receiving so you can hop right in as soon as they arrive. Good luck, bro!
ReplyDeleteSpencer. It's pretty cool that you got into the design competition. While you wait you should research and maybe practice drive a drone (I don't know with what). Good luck my friend.
ReplyDelete